How to replace a graphite shaft in a driver

Because the shaft is made of graphite, it tends to shatter when cut. To avoid that, wrap about three layers of tape where you will make the cut, then use a band saw to finish the job. Install your new shaft by applying a liberal amount of epoxy to the inside of the hosel of the club head and the tip of the shaft. Then marry the two and twist the club head slightly to make sure the epoxy is completely covering the area. Make sure the shaft is all the way inside the hosel by tapping the butt end of it on a hard surface.

Finally, replace the screw, if applicable. Let the club sit for about 24 hours to let the epoxy dry. Then place a small amount of the solvent inside the grip and swish it around to cover, then pour out what remains. Slide the grip onto the shaft until it is as far as it will go.

Apply mineral spirits with a wash cloth to remove any remaining residue. Cut a grip-length piece of new double-sided grip tape. The tape must be long enough to cover the entire grip area. Apply a wide piece of tape vertically, straight down the shaft, then wrap it around the club. Or wind thinner tape around the shaft in a spiral pattern, covering the entire grip area, including the opening on the end.

Peel off the outer protective layer of the tape. Cover the hole in the butt of the grip with your finger or a tee. Then pour an ounce activating liquid, such as mineral spirits, into the new grip. Shorten Golf Clubs. Replace a Callaway Graphite Golf Shaft. Install Ferrules. Change a Golf Shaft. Replace a Graphite Shaft on a Golf Club.

Install a Shaft in a Golf Club. Wrap the area where the grip will be placed with double-sided tape, then soak the tape with grip solvent.

Pour a small amount of the solvent inside the grip and swirl it around until it is completely covered, then pour out the remaining solvent. Slide the grip onto the shaft; then in the 15 or so minutes before it dries, make final adjustments to your shaft. Bill Herrfeldt specializes in finance, sports and the needs of retiring people, and has been published in the national edition of "Erickson Tribune," the "Washington Post" and the "Arizona Republic.

Writer Bio Bill Herrfeldt specializes in finance, sports and the needs of retiring people, and has been published in the national edition of "Erickson Tribune," the "Washington Post" and the "Arizona Republic. Most Popular. Golf Club Refinishing Tips. Making a Golf Putter. Fit a Golf Shaft.